Testing the LINKTools® Interface System
After installing, registering and configuring the LINKTools®
Interface, use the following procedures to test the system
Note: You can create both test interface
environment and production interface environment on the
same LINKTools® Interface server (cost-effective), however
your test system may needs a separate LINKTools® HL7
TCP/IP Receiver and Transmitter to communicate with your
client test system. You can purchase additional licenses
of the LINKTools® HL7 TCP/IP
Receiver and Transmitter pack for this purpose
To test the LINKTools® Interface System
The following described LINK Medical recommended
steps when testing your LINKTools® Interface System
- Configure the Inbound communication (TCP/IP Receiver)
to receive and send HL7 Acknowledgements for HL7 ADT or
Order messages
-
Start the LINKTools® Scheduler (pre-configured
interface only) for inbound interface
-
Download some orders using WebSelect client
application or import parsed data to your system
-
Configure the output template or transcription
template if required
-
Perform an outbound test result reporting
or transcribed report by uploading the report files to
LINKTools® Interface Module and generate HL7 result
message (ORU or MDM)
-
Verify that the HL7 result message is
configured according to the customer's requirements if
not adjust the Result Mapper Template if necessary
LINK
Medical Interface Services
LINK Medical provides resources needed to build
your Uni-directional or bi-directional HL7 interface
from start to go live. LINK cost-effective full
interface service includes: LINKTools® software,
LINK Medical system integration engineer assigned
to your account, your Interface documentation, interface
support and training
|
..........................................................................................................................................................
|
